Automation index
How much of a Aluminium carpenter’s job can AI already do?
A cutting list comes earlier. A tight close without the glass sweating do not.
This percentage does not predict how many people will lose their jobs.
Task comparison
IS WORK OVER?
Aluminium carpenter
21%
AI can already do 21% of this job.
#408 / 633
View rankingAluminium carpenter
Where the time goes
Task weights are our estimates based on O*NET frequency data, not time shares published by O*NET.
The time saving for each task is estimated separately.
| Task | Share | AI | Points |
|---|---|---|---|
Measure, cutting list and the profile cut.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 36% | +5.8 |
Assemble, squares and the frame in the opening.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 12% | +2.2 |
Glass, beads and the one that does not seal.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 22% | +3.5 |
Fittings, tilt-and-turn and the fine adjust.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 28% | +4.5 |
The dirty site and not scratching the anodising.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 18% | +3.2 |
A tight close, and not leaving water in.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 12% | +1.9 |
| Total | 100% | 21% |
Modelled workweek: 100% · Public evidence: 0% · Estimate: 100% · Confidence: Low
Skills and activities
- cut profiles
- assemble frames
- beads
- tilt-and-turn
- seal glass
- anodising
- squares
- measure openings
Sources for this job· O*NET 47-2211.00· ESCO/ISCO 7213
IS WORK OVER?
Tool and die maker
25%
#244 / 633
View rankingTool and die maker
Where the time goes
Task weights are our estimates based on O*NET frequency data, not time shares published by O*NET.
The time saving for each task is estimated separately.
| Task | Share | AI | Points |
|---|---|---|---|
Read the die, clearances and the 3D drawing.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 40% | +6.4 |
Machine, fit and try the tooling.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 18% | +3.2 |
Mount in the press, shoot and correct.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 22% | +4 |
EDM, polish and cavity finish.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 32% | +5.1 |
Die maintenance and changeovers.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 28% | +4.5 |
Die life and liability for the part.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 14% | +2.2 |
| Total | 100% | 25% |
Modelled workweek: 100% · Public evidence: 0% · Estimate: 100% · Confidence: Low
Skills and activities
- make dies
- fit tooling
- run EDM
- try out tooling
- polish cavities
- mount in the press
- maintain moulds
- correct clearances
Sources for this job· O*NET 51-4111.00· ESCO/ISCO 7222