Automation index
How much of a Labour inspector’s job can AI already do?
A site checklist comes earlier. Stopping the job and issuing the penalty do not.
This percentage does not predict how many people will lose their jobs.
Task comparison
IS WORK OVER?
Labour inspector
23%
AI can already do 23% of this job.
#299 / 633
View rankingLabour inspector
Where the time goes
Task weights are our estimates based on O*NET frequency data, not time shares published by O*NET.
The time saving for each task is estimated separately.
| Task | Share | AI | Points |
|---|---|---|---|
Plan visits, complaints and the firm’s history.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 40% | +6.4 |
Site or workplace, stop unsafe work and take statements.EstimateNo public source provides a precise figure. This is our estimate. | 22% | 12% | +2.6 |
Minutes, orders and the penalty proposal.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 32% | +5.1 |
Contracts, hours and the bogus self-employed.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 28% | +4.5 |
Union, employer and what is argued in the corridor.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 18% | +2.9 |
A penalty that holds, and not looking away.EstimateNo public source provides a precise figure. This is our estimate. | 14% | 12% | +1.7 |
| Total | 100% | 23% |
Modelled workweek: 100% · Public evidence: 0% · Estimate: 100% · Confidence: Low
Skills and activities
- visit sites
- stop unsafe work
- infringement minutes
- bogus self-employment
- check contracts
- labour orders
- fine firms
- take statements
Sources for this job· O*NET 13-1041.00· ESCO/ISCO 3352
IS WORK OVER?
Lathe operator
26%
#214 / 633
View rankingLathe operator
Where the time goes
Task weights are our estimates based on O*NET frequency data, not time shares published by O*NET.
The time saving for each task is estimated separately.
| Task | Share | AI | Points |
|---|---|---|---|
Read the drawing, tolerances and the route card.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 40% | +6.4 |
Set up, clamp, pick the tool and the origin.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 18% | +3.2 |
Turn, face, thread and finish the part.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 28% | +5 |
Measure, tweak offsets and not scrap the batch.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 36% | +5.8 |
Lathe care, swarf and safety.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 22% | +3.5 |
Grades, times and liability for the dimension.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 14% | +2.2 |
| Total | 100% | 26% |
Modelled workweek: 100% · Public evidence: 0% · Estimate: 100% · Confidence: Low
Skills and activities
- turn parts
- set up the lathe
- measure dimensions
- cut threads
- adjust offsets
- read mechanical drawings
- avoid scrap
- pick tools
Sources for this job· O*NET 51-4034.00· ESCO/ISCO 7223