Automation index
How much of a Plasterboard fitter’s job can AI already do?
A setting-out comes earlier. Partition plumb and not hearing the neighbour do not.
This percentage does not predict how many people will lose their jobs.
Task comparison
IS WORK OVER?
Plasterboard fitter
19%
AI can already do 19% of this job.
#524 / 643
View rankingPlasterboard fitter
Where the time goes
Task weights are our estimates based on O*NET frequency data, not time shares published by O*NET.
The time saving for each task is estimated separately.
| Task | Share | AI | Points |
|---|---|---|---|
Setting-out, tracks and the board cut list.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 32% | +5.1 |
Studs, boards and the screw to the noggin.EstimateNo public source provides a precise figure. This is our estimate. | 22% | 8% | +1.8 |
Insulation, joints and hearing the neighbour.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 22% | +3.5 |
Jointing, corners and the painter behind.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 28% | +4.5 |
Services, pipe runs and not chopping extra.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 18% | +2.9 |
Plumb, and not leaving the joint proud.EstimateNo public source provides a precise figure. This is our estimate. | 14% | 12% | +1.7 |
| Total | 100% | 19% |
Modelled workweek: 100% · Public evidence: 0% · Estimate: 100% · Confidence: Low
Skills and activities
- fit plasterboard
- set out partitions
- tracks
- jointing
- acoustic insulation
- boards
- corners
- service runs
Sources for this job· O*NET 47-2081.00· ESCO/ISCO 7123
IS WORK OVER?
Lathe operator
26%
#219 / 643
View rankingLathe operator
Where the time goes
Task weights are our estimates based on O*NET frequency data, not time shares published by O*NET.
The time saving for each task is estimated separately.
| Task | Share | AI | Points |
|---|---|---|---|
Read the drawing, tolerances and the route card.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 40% | +6.4 |
Set up, clamp, pick the tool and the origin.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 18% | +3.2 |
Turn, face, thread and finish the part.EstimateNo public source provides a precise figure. This is our estimate. | 18% | 28% | +5 |
Measure, tweak offsets and not scrap the batch.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 36% | +5.8 |
Lathe care, swarf and safety.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 22% | +3.5 |
Grades, times and liability for the dimension.EstimateNo public source provides a precise figure. This is our estimate. | 16% | 14% | +2.2 |
| Total | 100% | 26% |
Modelled workweek: 100% · Public evidence: 0% · Estimate: 100% · Confidence: Low
Skills and activities
- turn parts
- set up the lathe
- measure dimensions
- cut threads
- adjust offsets
- read mechanical drawings
- avoid scrap
- pick tools
Sources for this job· O*NET 51-4034.00· ESCO/ISCO 7223